Bootleg - PWS Marksman 3 Gun DI 14.5"
BOOTLEG - PWS - ENHANCED LIGHTWEIGHT AR-15 COMPLETE RIFLE INCLUDING 14.5" Barrel, Adjustable Bolt Carrier and Charging Handle and PWS Lower
This is a complete Direct Gas Impingement version of the PWS Piston Rifle with an adjustable Bolt Carrier Group instead of a adjustable gas block. It looks the same as the PWS Piston Rifle but it is DI and therefore lighter. Comes in either 14.5" or 16" and can be attached to the PWS Lower or and AR-15 Lower. It comes with a TRIAD compensator.
This is sold in A Cat configuration only with the Gunsnz A Cat Stock.
Bootleg Inc. was formed as a sister company of Primary Weapons Systems (PWS) in 2015, with a sole focus on Direct Impingement or DI accessories and builder education. Our goal is to provide quality products and information for anyone that would like to build an AR-15. We will have a searchable database for frequently asked questions as well as an education center for new builders. If you have a question that has not been answered, please let us know.
The Bootleg upper receiver is machined from 7075 aluminum and mil spec hard anodized. It features a lightweight design and upgraded features to start your build off right.
- Machined from forged 7075 Aluminum
- Mil Spec Hard Anodizing
- Forward assist eliminated for weight saving and reduced snag risk
- Lightweight design 6.2 oz stripped (.8 oz lighter than a mil spec upper receiver)
- 1.7 oz lighter than a mil spec upper receiver with hardware installed
- Captured dust co
The new ZEV Technologies SSR (Single Stage Rifle) Trigger is designed to bridge the gap between the multitude of two stage triggers intended for duty use, and single stage competition triggers.
The ZEV SSR Trigger ships with two hammer springs allowing for a 5lb to 5.5lb trigger pull weight or a 3lb to 3.5lb trigger pull weight depending on which hammer spring is used.
The installation instructions can be fo found HERE. What they don't tell you in the Instructions is that the locking groove on the trigger pin goes on the left. When installing the Hammer Pin Cock the Hammer first or you will never get it in and back ou ALL the adjustment screws before installing the trigger unit and follow the instructions for setting the three screws. DO not use your old trigger pins but use the ones provided as they have special grooves .