KIDD Black Trigger Job Kit aftermarket upgrades for the 10/22.

Description:

• Internal upgrade for your polymer 10/22® trigger guard 
• Complete with Hammer, Sear, Disconnect, and Trigger Blade 
• No Filing or Stoning!
• From a cumbersome trigger break to a clean one- 20 minutes
• Pull weight 2.25 lbs.

Upgrade your polymer factory 10/22® trigger break with our "trigger job" kit. This kit will replace your weighty factory trigger break with a clean crisp break.  This kit replaces your internal hammer, sear, disconnect, and trigger blade with precision aftermarket parts.  KIDD has taken some of the work out of this installation by creating two sub-assemblies.  The first sub-assembly is the mated hammer bushings and fitted hammer pin. The second is the sear, disconnect, and trigger blade sub assembly.  We have fine-tuned these sub-assemblies to both assist the customer with installation and assure proper settings.

When using our kit you must not mix and match our pieces with other aftermarket or OEM hammers, sears, disconnects, or trigger blades in order to achieve the ultimate potential of this kit. This entire kit will drop into your factory polymer/plastic trigger guard well within 20 minutes from start to finish and the normal trigger breaking weight achieved is just under 2 pounds.  This kit was not designed to work in the metal Ruger® housings as the tolerances were not as consistent compared to their polymer units.  It will not work in the Thomas Center .22 or the Bergara® BXR.