Barrett 35mm Ultra High 1.4" ZERO GAP Scope Rings

BARRETT 35mm Ultra High 1.4" ZERO GAP Scope Rings

For use with Leupold Mark 5HD 5x25x56.
Barrett Rings 15363

SEAMLESS PERFECTION.

Unlike traditional scope rings which require careful attention be paid to maintaining equal gap between the upper and lower ring halves, Barrett’s ZERO-GAP technology eliminates this tedious process. Simply tighten the cap on the indicated side, verify reticule alignment, tighten the remaining side, and fire away. The end result is a perfect fit between scope and mount that will withstand even the heaviest recoiling rifles. Machined from 7075-T5 aluminum and with MIL-SPEC Type III anodized finish, ZERO-GAP Rings are available in a variety of heights for both 30mm, 34mm, and 35mm optics. Simplicity at its finest. 

Weight: 8.32oz (235.9g) (30mm), 8.45oz (239.6g) (34mm)

Size: 30 mm, 34 mm

Base Type: Mil-STD 1913 Rail

Tensile Strength: 83 ksi

Ring Width: 1.2" (3.05 cm)

Surface Gripping Area: 8.192 inch²

Material: 7075 T-6 Aluminum

Finish: Hard Anodized Black

Height (Contact Point to Scope Ring Center): 1.0"-1.7"

For use with 30 mm riflescope tubes on M1913 accessory rails
1.2" wide clamping area positively grips without damaging scope tube
Aircraft quality 7075 T-6 aluminum
60 HRC (Rockwell C scale) hard-anodized
2.5 times lighter than similar steel rings
Integral 1/4 - 32 steel cross bolt with captured 1/2" nut

MATERIALS AND MASS